Cross / J

Cross Perforation Plan

Cross perforation combines different hole sizes to create a more detailed wall surface and broader acoustic response. It is suitable for studios, multi-function halls, and feature acoustic walls.

Combined diameter 6/10 mm, 8/12 mm Perforation rate about 9%-19.6% Broadband acoustic direction

Cross perforation engineering drawing thumbnail

Typical Diameter 6/10 mm, 8/12 mm Combined hole sizes provide more acoustic and visual variation.

Perforation Rate 9%-19.6% Density can be adjusted according to room acoustic targets.

Use Case Studio / Multi-function hall / Feature wall Suitable for spaces where acoustic function and visual detail both matter.

CAD Drawing

Cross CAD drawings

1200 x 2400 factory CAD drawings show D6/D10 combined round holes and U layout references.

D6 / D10

Combined hole layout

2400 x 1200 panel layout for combined hole diameter detailing.

U Layout / 15.4%

U layout reference

A special combined hole layout that can be adapted for project-specific acoustic surfaces.

Acoustic

Broadband balance

Combined hole diameters support a more balanced response between mid-low and mid-high frequencies.

Design

Richer surface rhythm

Alternating hole sizes create more detail than a single-hole pattern and suit feature acoustic walls.

Detailing

Zone control

Different density zones can be coordinated within the same panel system.